User Tools

Site Tools


This is an old revision of the document!

Pi Cameras

There are several Raspberry Pi cameras scattered through the North Texas area on various repeater sites. These cameras are quite simple; they consist of a Raspberry Pi, a Pi Camera, and a POE “uninjector”.

The Pi cameras are configured to run a shell script as a systemd service. This shell script will take a picture every 10 seconds using raspistill, and then sort it into three directories: hourly, daily, and weekly. Filenames are assigned img_%s.jpg where %s is the UNIX epoch time. All pictures are stored in the hourly directory. If (%s % 60 == 0), once a minute, then the picture is copied to the daily directory. If (%s % 300 == 0), once every 5 minutes, then the picture is copied to the weekly directory.

Once a minute a picture is uploaded to the DCARA VPS. Once an hour, a cron job will rsync all photos from the hourly directory to a server on Guinn Hall (the “Fog Server”), which will then compile the pictures into a timelapse and upload them to the VPS. Every morning a similar process is repeated for the daily timelapses, and every Sunday it is repeated for the weekly timelapses.


The hardware consists of a Pi, Pi Camera, SD card (Samsung preferred for reliability reasons), PoE “uninjector”, outdoor box, and weatherproof lens.

The Pi is powered via ethernet. On some designs a simple device is used to pull the power pairs from the Ubiquiti PoE standard and feed those to a 5v switching DC buck. In other designs a 48v PoE to 5v adapter is used. By regulating in the camera box, line loss over a long CAT5 run can be compensated for.

The camera is mounted on standoffs inside the box. A hole is drilled to allow the camera to see out of the box, and is covered by a UV filter. The filter is sealed with RTV. See for a picture of the box.

Potential Issues

The primary issue that will cripple a Pi camera is a MIPI bus error between the Pi and the camera. This can be identified by a hung raspistill process and a picture filename ending in .jpg~. The issue can be solved by deleting the file ending in .jpg~, and rebooting the Raspberry Pi.

project/picameras.1523506671.txt.gz · Last modified: 2018/04/11 23:17 by ke5gdb