This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
site:guinn:guinnrouterx [2018/02/20 13:30] ke5gdb [Port Forwarding] |
site:guinn:guinnrouterx [2018/02/26 08:49] (current) ke5gdb |
||
---|---|---|---|
Line 13: | Line 13: | ||
Due to the complicated nature of the Dual-WAN setup, port forwarding is not supported by the regular port forwarding utility. To forward a port, follow these steps. | Due to the complicated nature of the Dual-WAN setup, port forwarding is not supported by the regular port forwarding utility. To forward a port, follow these steps. | ||
- | NOTE: The Firewall policies are applied //after// DNAT translation. The port entered in the WAN_IN firewall section should be the port of the local device if it differs from the public port. | + | NOTE: The firewall policies are applied //after// DNAT translation. The port entered in the WAN_IN firewall section should be the port of the local device if it differs from the public port. |
- Make a backup | - Make a backup | ||
Line 28: | Line 28: | ||
- Under the "Destination" tab, enter the IP address and ports (comma separated or hyphenated, no spaces) | - Under the "Destination" tab, enter the IP address and ports (comma separated or hyphenated, no spaces) | ||
- Click "Save" | - Click "Save" | ||
- | - Move the rule //above// the "Drop invalid state" rule | + | - Move the rule (click & drag) //above// the "Drop invalid state" rule |
- Click "Save Rule Order" | - Click "Save Rule Order" | ||
- Navigate to Firewall/NAT > NAT and click "Add Destination NAT Rule" | - Navigate to Firewall/NAT > NAT and click "Add Destination NAT Rule" | ||
Line 34: | Line 34: | ||
- Select eth0 from the "Inbound Interfaces" menu | - Select eth0 from the "Inbound Interfaces" menu | ||
- Enter the device IP address and port in the "Translations" area | - Enter the device IP address and port in the "Translations" area | ||
- | - If the public port is different than the private port | + | - Enter the public port in the "Dest Port" port field (required!) |
- | - Enter the public port in the "Translations" port field | + | - Enter the private port in the "Translations" field (required!) |
- | - Enter the private port in the "Dest Port" field | + | |
- Click Save | - Click Save | ||
- In the list of Destination NAT Rules, find the newly created rule and click Actions > Copy | - In the list of Destination NAT Rules, find the newly created rule and click Actions > Copy |