The GuinnRouterX is a Ubiquiti EdgeRouter X that drives the majority of the DCARALAN network.

This page is intended to serve as documentation for some of the configuration aspects of the router.

There are two WAN ports, eth0 and eth1, that are configured for automatic failover. KC5GOI sources internet to eth0, and N5LS sources internet to eth1.

Due to the complicated nature of the Dual-WAN setup, port forwarding is not supported by the regular port forwarding utility. To forward a port, follow these steps.

NOTE: The Firewall policies are applied after DNAT translation. The port entered in the WAN_IN firewall section should be the port of the local device if it differs from the public port.

1. Navigate to Firewall/NAT > WAN_IN > Actions > Edit Ruleset
2. If the destination device is already listed, click Actions > Destination and append the port to the “Port” field
3. If the destination device is not listed, click “Add New Rule”
4. In the Add New Rule popup box, enter a brief description (no spaces allowed)
   1. Action: Accept
   2. Protocol: [choose]
5. Under the “Destination” tab, enter the IP address and ports (comma separated or hyphenated, no spaces)
6. Click “Save”
7. Move the rule above the “Drop invalid state” rule
8. Click “Save Rule Order”